Rheonics sensors output the measurements which are referred as parameter. These start at index 0. The output measurement for each parameter is shown in the list below.
Parameter List:
Index | Parameter |
0 | viscosity median / 5 measurements |
1 | density median / 5 measurements |
2 | temperature median / 5 measurements |
3 | Kinematic Viscosity |
4 | density average / 5 measurements |
5 | V - viscosity raw |
6 | D - density raw |
7 | T - temperature raw |
8 | f - resonant frequency (Hz) |
9 | fc - compensated resonant frequency (Hz) |
10 | df - damping (Hz) |
11 | Tc - Coil temperature |
12 | viscosity median and last good |
13 | density median and last good |
14 | Displays of mapped value from Modbus register 512 |
15 | Displays of mapped value from Modbus register 514 |
16 | Displays of mapped value from Modbus register 516 |
17 | Te - Estimated Temperature (from internal temperature Algorithm) |
18 | Tp - Temperature from PT1000 sensor present in sensor |
19 | Calculated parameter from viscosity model |
20 | Calculated parameter from density model |
21 | Calculated parameter from concentration model |
22 | Sensor cleanliness ratio |