Rheonics Dataview Windows offers an extended and customized view for measured parameters.

When the dataview button is clicked from the measurements tab, a new window is opened.

Figure 1. Opening dataview

The measurements window by default shows two graphs, as shown in picture below; the first one plots density and viscosity, the second plots temperature and pressure. 

1. On the top of the window, current measurement values are shown. 

2. By clicking the settings button, the “Settings” page is viewed. 

3. On the left side of the first plot a tools palette allows to move, vertical zoom, horizontal zoom, and fit the plot. When one of the tools is selected the control is highlighted and the mouse pointer changes when passed over the plot area. The tool can be disabled by clicking it again. 

4. Shows the plot area of the first plot. 

5. Tools palette of the second plot. 

6. Plot area of the second plot. 

Figure 2. Measurement view

2.1. By clicking in “Graph Fitting” button, a fit graph will on the screen

Figure 3. Graph fit

2.2. To take a snapshot click in “Camera” Button and a save screen is going to appear to save the image.

Figure 4. Snapshot

3.1. When the “Settings” button is clicked the windows switches to a settings page (Refer to image below). 

Figure 5.Settings window

3.2. Window navigation

        1. Click this button to go back to “measurements” page. 

        2. Y axis settings for plot 1; the parameters to be plotted on each one of the two axes can be selected. Also, the             graph itself can be made visible or not visible by checking the “Display plot” control. 

        3. Y axis settings for plot 2. 

        4. X axis settings; in this section the plot time can be modified. Top is 24 hours for real time plot update. It is                  independent of the time of the RCP graphs. 

        5. For Molecular Weight Only: The Dataview window has the capability of calculating the molecular weight for             ideal gases. If Molecular weight is plotted on any of the charts, the y axis range, units and resolution can be                     modified. The calculation of molecular weight can be disabled. 

Figure 6. Settings View

For viscosity, density, temperature and pressure units and ranges, and for time interval, the Dataview takes the settings from the “Settings” tab of RCP.