1. Checking your local IP address
1.1.Open Control Panel
Figure 1. Control Panel Search
1.2.Select Network and internet
Figure 2. Network and Internet
1.3.Click “Change adapter Settings”
Figure 3. Adapter Settings
1.4. Find your IP address, Right click the Ethernet icon and select Status from the context menu.
Figure 4. Status check
1.5. Look into the details of your own network
Figure 5. Network settings
1.6. Set the IP address, Right Click Local Area Connection and select Properties.
Figure 6. Properties Menu
1.7.Double click Internet Protocol Version 4 (TCP/IPv4).
Figure 7. Internet protocol version 4 (TCP/IPv4)
1.8. Select “Use the Following IP address:” and type in the IP address, Subnet mask and Default gateway. Click OK to apply the settings.
Figure 8. Setting Io Address.
2. Configuring the static IP address in the SME
2.1. Open RCP and select “Communication” Tab. The following steps should be done with USB communication in the “Setting tab”
Figure 9. Communication tab in RCP
2.2. Fill Ethernet parameters
Figure 10. Ethernet Parameters
2.3. Click in “Write config” button.
Figure 11. Uploading parameters
2.4. Enable IP address in RCP, go to the setting tab and select Ethernet in the radio button, fill in the same Ip address you used in the “Communication” tab, and click “Apply” button. If everything is correct status led should be green.
Figure 12. Setting Tab