Modbus RTU (RS-485)
General All SME devices implement a MODBUS RTU compliant RTU slave. The default configuration of the MODBUS RTU slave is 38400 and ODD parity. Connec...
Thu, 8 Jul, 2021 at 5:28 PM
The table uses PDU addressing; addresses start at zero. Depending on the PLC used it might be required to add 1 to the addresses in the table below. Mod...
Thu, 29 Feb, 2024 at 6:59 PM
Float: IEEE754 floating point. This data type spans two registers which should be read together. Depending on the endianness of the host it might be necess...
Fri, 3 Jul, 2020 at 2:03 PM
This section helps with the syntax for Modbus RTU Commands and Responses for the mostly used Rheonics parameters. Reading the parameter 2, Temperature me...
Thu, 29 Feb, 2024 at 6:58 PM
ModbusPoll is a commercially available software from Witte GmbH. 1. Intro to Modbus RTU on Rheonics SME All SME devices implement a MODBUS RTU-compliant ...
Thu, 30 Nov, 2023 at 12:13 AM
1.MODBUS RTU TROUBLESHOOTING 1.1.Verify the Baud Rate, Stop Bits, Data Bits and Parity. Factory default settings of Modbus parameters: address=1 baud...
Thu, 29 Feb, 2024 at 6:59 PM
Modbus RTU is available on Rheonics process density meters and viscometers over a 2-wire RS-485 interface. The device does not have internal biasing resisto...
Thu, 7 Dec, 2023 at 11:13 PM
The Modbus Organization is a group of independent users and suppliers of automation devices that seeks to drive the adoption of the Modbus communication pro...
Wed, 28 Feb, 2024 at 10:56 PM