RCP - Rheonics Control Panel
Rheonics standard software for USB and ethernet serial access to sensors (SRV, SRD, DVP, DVM) for data logging, plotting, communication configuration and calibration verification
Operating System: Windows 7 or Higher (Windows 10 recommended) Required: LabVIEW Run-Time Engine 2019, and NI-VISA Run-Time Engine 19.0. Included in the fu...
Fri, 3 Jul, 2020 at 11:43 AM
The installation software is supplied on a USB drive (USB stick, flash drive). Updates can also be downloaded from Rheonics website, contact support. O...
Fri, 3 Jul, 2020 at 12:51 PM
If you have installed an old version of RCP, and want to do an update for a new version, You could use the "RCP_Lite_VX.X.X.X.exe" installer prov...
Fri, 3 Jul, 2020 at 12:40 PM
The USB driver provides a virtual COM-Port on the computer used for the Rheonics Control Panel. For Windows 10 users: The Drivers should install automatica...
Fri, 3 Jul, 2020 at 12:58 PM
Open the Rheonics Control Panel application from the Start menu or from its Desktop icon, if created during the installation process. When the sof...
Fri, 3 Jul, 2020 at 1:18 PM
Rheonics Dataview Windows offers an extended and customized view for measured parameters. 1.Opening dataview When the dataview button is clicked from t...
Thu, 28 Apr, 2022 at 5:55 PM
Scaling is an important tool when performing a calibration and/or correlating two or more values. Most of the time, a process measurement is compared agains...
Thu, 5 May, 2022 at 12:12 PM
1. How to create log files? Logging data points is an useful tool in the process management, since this measure data can be used for further analysis and...
Thu, 28 Apr, 2022 at 5:54 PM
1. Setting limits on the RCP Below find how to configure the communication channels on the sensor, also the useful tools RCP provides 2. 4-20mA Settin...
Tue, 10 May, 2022 at 5:16 PM
The external pressure library works to retrieve the pressure measurements from an external pressure sensor, and write the pressure value back to the SME. ...
Thu, 25 Aug, 2022 at 5:44 AM