Rheonics Support

4-20 mA 4

• Connecting 4-20 mA outputs
• What can go wrong with 4 - 20mA loops ?
• Setting 4-20mA range for getting the full range while ensuring sufficient sensitivity to viscosity change
• Analog signals setup with the RCP

Modbus RTU (RS-485) 8

• Connecting Modbus RTU (RS-485) outputs
• Modbus Input Registers
• Data-Types (Modbus RTU RS-485)
• Modbus RTU Command and Response Examples
• Quick Modbus RTU connection verification with ModbusPoll master software

View all 8

Modbus TCP (Ethernet) 8

• Connecting the Modbus TCP outputs
• Modbus TCP - Protocol
• Modbus TCP - Input Registers
• Modbus TCP - Data Types
• Modbus TCP Command and Response Examples

View all 8

Ethernet 4

• Introducing Ethernet connections on SMET
• How connect ethernet cables to the SME-TRD?
• Verifying the network setup on the PC where the RCP software is installed
• Can I connect to the Rheonics Sensor using a straight-through ethernet cable directly from the computer?

USB 3

• Introducing USB connections on the Rheonics SMET (sensor electronics)
• Nothing is happening when I plug in the USB cable!
• Network Setup through USB communication for Rheonics SME

HART 9

• Which variables are offered by Rheonics for the HART protocol?
• HART Troubleshooting
• Host Interface and wiring diagram for HART protocol
• Read/Write Density with HART protocol
• Where to find the sensor serial number and sensor type with HART commands?

View all 9

Ethernet/IP 10

• EthernetIP EDS file for Rheonics inline viscometer and density meter
• Data point access over ETHERNET/IP
• Ethernet/IP troubleshooting
• Connecting the Ethernet/IP output
• Checking the sensor serial number with RSLINX classic

View all 10

PROFINET 9

• Profinet GSD file for Rheonics inline viscometer and density meter
• Profinet Troubleshooting
• Connecting the Profinet output
• PROFINET fundamentals
• Getting started with PROFINET on Rheonics devices

View all 9